http://www.publicsurplus.com/sms/auc...iew?auc=677607 , if your near amarillo might wannna check it out
BT-3OOO Up for bids in Texas
Collapse
This topic is closed.
X
X
-
Very old, old BT3000.
Note as evidence:
13A motor (from label)
Date code: 20th week (around May) 1992 (From label)
Aluminum metal elevation handle (you can tell by the open web)
Bad switch (stated in description)
not 100% sure but I think I see it has the old two-button switch which is still eligible for free replacement from Ryobi.
All of these were gone by end of year one or two of production and they made the BT3000 for almost ten years starting around 1992,
well they did manage to revert to a bad switch but that was much later and into the BT3100 models.Last edited by LCHIEN; 02-17-2012, 09:49 PM.Loring in Katy, TX USA
If your only tool is a hammer, you tend to treat all problems as if they were nails.
BT3 FAQ - https://www.sawdustzone.org/forum/di...sked-questions -
Same switch that's on mine, 42nd or 45th week of '95 if i recall correctly. Every time i've called i get the same guy who tells me that i have to take it to a factory authorized facility (about 30 miles, and i'd need to take the legs off for the car ride). Haven't been able to convince him that it's more efficient for me to replace the switch. I've considered just ordering a replacement--cheaper than spending 15 or 20 minutes on the phone. Then i could quit banging on it to turn it off.
earlComment
Footer Ad
Collapse
Comment