One of the few mishaps in moving into my new shop was dropping the piece of plate glass I used for sharpening. I picked up an off cut of granite approx 5"x48" for $5. I guess it was previously a backspalsh but its a bit big for my needs so I need to cut it into one or two smaller pieces. I have never tried cutting this type of material before.
Not 100% sure if its natural stone or one of the man made alternatives but does anybody have any experience doing this? I only really need to make a couple of cuts across the 5" width but what should I use jig saw, circular saw? and is there a special blade I should get?
Not 100% sure if its natural stone or one of the man made alternatives but does anybody have any experience doing this? I only really need to make a couple of cuts across the 5" width but what should I use jig saw, circular saw? and is there a special blade I should get?
Comment