Does anyone have this little guy (http://www.harborfreight.com/1-4-qua...r-44914.html)?
I got one yesterday and haven't even ran it yet. I found that the base plate is not flat on one direction -- maybe there's a 1/16" of movement. I'm wondering if anyone had the same issue or I just got a bad one. If it's just my then I'll go switch it; otherwise, I'd just sand/flatten the bottom down. My fear with the latter is that I might cause the plate to be not perpendicular to the bit holder.
Thanks,
I got one yesterday and haven't even ran it yet. I found that the base plate is not flat on one direction -- maybe there's a 1/16" of movement. I'm wondering if anyone had the same issue or I just got a bad one. If it's just my then I'll go switch it; otherwise, I'd just sand/flatten the bottom down. My fear with the latter is that I might cause the plate to be not perpendicular to the bit holder.
Thanks,
Comment