A few years back I bought a set of countersink bits from Grizzly. They haven't seen much use but they've frustrated me from day one.
Basically it's impossible to tighten the set screws to the point where they actually hold. If you try, they strip out, and will still slip.
Is this common with countersink bits? Can someone recommend a set that isn't insanely priced that actually works?
Thanks!
Basically it's impossible to tighten the set screws to the point where they actually hold. If you try, they strip out, and will still slip.
Is this common with countersink bits? Can someone recommend a set that isn't insanely priced that actually works?
Thanks!
Comment