Its been a while since I started my shop conversion project. In my original post Pimp My Shop, I received a lot of advice on ways to improve the work space. I have subsequently done quite a bit of work and added some major equipment. Here is what I've done.
- Removed All the kids toys and other storage items
- Cleaned out junk tools/other crap
- Added Craftsman 21829 TS
- Added Jet 12" BS
- Added HF 2HP DC + Wynn Canister
- Built assembly table
- Built cutoff storage
- Replaced two small fluorescent lights and added 4 additional larger lights (6 total)
- Added 3x4 outlet overhead boxes (re-ran wire/conduit)
- Added 4x2 outlet boxes on wall where DP table and DC are located
- Removed router table from work bench (see future plans)
- Lowered workbenches from 38" to 36"
- Rearranged some of the tools to take advantage of new electrical configuration.
- Close off Water Heater, and furnace
- Run DC duct work
- Build Router Table
- Build cabinets under work benches
- Build better stands for DP, sander and Scroll saw
- Add BIL's Planer and Jointer
Comment