My apologies as I'm not sure if this should be in this forum or the tool forum (given this is an accessory).
I'm looking to buy my first Dado set for my BT3100. I would like to try and cut some lap joints but would like to use it for any and everything obviously. I do have a PC jig for box (and dovetail) joints.
$100 range or less preferably.
More importantly, what should I consider in terms of compatibility to the saw. For instance, I read a post from LCHIEN I believe stating that 6" and 8" each had its own pros and cons.
In all honesty, when I was searching Rockler online, I was actually looking for 10" Dado sets because I assumed it would be the same size as the regular table saw blade. So this proves I know very little. I do know that I can't afford those "dial" sets.
Thank you.
I'm looking to buy my first Dado set for my BT3100. I would like to try and cut some lap joints but would like to use it for any and everything obviously. I do have a PC jig for box (and dovetail) joints.
$100 range or less preferably.
More importantly, what should I consider in terms of compatibility to the saw. For instance, I read a post from LCHIEN I believe stating that 6" and 8" each had its own pros and cons.
In all honesty, when I was searching Rockler online, I was actually looking for 10" Dado sets because I assumed it would be the same size as the regular table saw blade. So this proves I know very little. I do know that I can't afford those "dial" sets.
Thank you.
Comment